Konifera BW28000, Инструкция по установке

Страница: 19 / 23

- 19 -
5
Check if the awning is level with the use of the spirit
level on the front bar.Adjust the angle adjuster at either
end by loosening the locking nuts of the angle adjuster
,turn the jack bolt to adjust the pitch.Adjust the arm until
the front profile is level.Tighten the locking nuts again
to fix the level of awning.
To adjust the inclination of the awning,adjust the angle
adjuster on both arm shoulders to achieve the desired
inclinaton.Fix the locking nuts when the awning is level.
Installation of awning to wall bases
Remove the bolts on the front of the wall bases.Install the awning to the wall bases by
attaching the square torsion bar to the wall bases.Lock the awning in place by replacing the
bolts and nuts on wall bases.Tighten the nuts to ensure the awning is attached to wall bases
securely.
Switch box and cable installation procedure
WARNING! Important safety instructions. Follow the instructions, since incorrect installation can
lead to severe injury. Wrong connection of electrical wiring can lead to electric shock and death
.
1. Open the pack and make sure there is no missing components. Use only the parts provided
in the pack. Open the switch box and take out the grey rubber pads at the top and bottom
ends.
09030-BW28000.indd 19 04.10.18 20:09