KONICS DPU Series, Руководство пользователя

Страница: 15 / 21

DPU
Series
E-16
■ Operating Mode [
OP
]
Displays operating mode.
Set soft start time.
• Set range : 0 to 100sec
Set limit output value.
• Set range : 0 to 110%
Set start limit time.
• Set range : 0 to 100sec
Set output slope manual adjustment.
Set output change ratio by control input.
• Set range : 0.00 to 1.00%
※
Not displayed when output slope manual adjustment [
A-GA
] is ON.
Set base-up value.
• Set range : 0 to 100%
Set output low-limit.
• Set range : 0 to 110%
Set output high-limit.
• Set range : 0 to 110%
Set current limit value.
• Set range : 0 to 110%
• Set range : 0 to 100%
※
Displayed only when
DI-1
to
DI-3
of
ST-1
mode is set
SP-M
or
SP1
to
SP3.
Set proportional constant.
• Set range : 1 to 2000
※
Displayed only for static voltage, static current, static power in phase control.
Set integral constant.
• Set range : 0.1 to 999.9
※
Displayed only for static voltage, static current, static power in phase control.
• Set range : 0 to 100%
※
Displayed only when
DI-1
of
ST-1
is set
SP-M
.
Set slow-up time.
• Set range : 0 to 999sec
※
Not displayed when C-MD mode is set as cycle control.
Set slow-down time.
• Set range : 0 to 999sec
※
Not displayed when
C-MD
mode is set as cycle control.
OP
H-OL
50 ST-T
C-LM
S-LM
SP1
S-LT
SP2
A-GA
SP3
SLOP
SP4
B-UP
SP5
UP-T
SP6
DN-T
P
L-OL
I
P
Operating mode
Soft start time
Start limit
Start limit time
Output slope
Base up
Slow up
Slow down
Output low-limit
value
Output high-limit
value
Current limit
Setting point 1
Setting point 2
Setting point 3
Setting point 4
Setting point 5
Setting point 6
Proportional
constant
Integral constant
Output slope
manual adjustment
※
1
OFF ON
Parameter mode
RUN
mode
Press key
for 3 sec.
※
1.
P
: Press any key among , .
※
To return RUN mode, press the key at any parameter, or not to operate any keys in 30sec.
※
: This parameter may or may not appear, depending on the other parameter settings.