Konica Minolta KN-303, Руководство по обслуживанию

Страница: 28 / 30

4-3 KN-303 Network Interface Card
Chapter 4 Appendices
●
Jumpers
Caution:
⇑
If grounding is not made securely, the cards can be damaged during work. Make
sure to ground your body securely by using a wrist strap before starting to work.
⇑
Don’t move any jumpers other than OP2.
OP2: Reset
This allows you to restore the default values of the parameters set up before shipment.
You can reset the KN-303 normally by using MAP/browser from the computer via the network.
If you cannot use the method of using MAP/browser, perform the following procedure.
1. Turn off the copier and then remove the KN-303 from the print controller.
2. Set the jumper OP2 as illustrated below. Connect the KN-303 to the print controller, then
turn on the copier.
The KN-303 will restore the default settings in about 5 minutes.
3. Turn off the copier, remove the KN-303, and move the jumper OP2 to the position where
it was set initially.
4. Connect the KN-303 to the print controller, then turn on the copier.
Now the system is ready to operate.
OP2
OP3
OP4
OP5
OP7
OP1
OP6
OP9
OP2
OP3
OP4
OP5
OP7
OP1
OP6
OP9