E-5
9. Install the back cover of the FS-503 (5 screws).
10. Remove the protective cover from the connector
of the FS-503, and pull out the connector toward
the back cover.
11.Install the FS-503 to the machine.
(1) Align the top and bottom holes of the FS-503
to the Installation plate/1 pins, and lock them
by sliding the FS-503 to the back.
Note:
If the vertical opening between the FS-503 and the
machine is not even and their heights are different,
adjust the height of the four casters of the FS-503
to make the opening even.
(2) Connect the three FS-503 connector jacks to
the connector plugs of the machine on the
paper exit side.(One small 2pin connector will
not be used.)
(3) Install the Connector cover.
(TP screw (black) M3x6: 2 pcs.)
Place to pull out
the connector jack
Connector jack
15AEIXE009SA
Top
Bottom
FS-503
Machine
Holes
Installation plate/1
15AEIXE010SA
Skew adjustment
15AEIXE011SA
Machine connector plugs
FS-503 connector jacks
Do not use this
15AEIXE012SA
Connector cover
TP screws
(black) M3x6
15AEIXE013SA
