E-5
(6) Remove the three screws, release the six tabs,
and remove the control panel assembly.
Note:
Do not use too much force when removing as the
cable is connected.
(7) Remove the cable from the control panel assem-
bly.
(8) Remove the bracket shown in the illustration.
(Two screws)
Note:
Discard the removed screws.
(9) Remove the bracket from the USB cable.
(Two screws)
Note:
The two removed screws are used in later step.
Do not discard them.
(10) Connect the USB cable removed in step (9) to
the local interface board unit.
(11)
<When mounting the Authentication Unit AU-201S
to the Working Table WT-506>
Refer to the installation manual for the Authenti-
cation Unit AU-201S and install the authentica-
tion unit.
<When mounting the Authentication Unit AU-102 to
the Working Table WT-506>
Refer to the installation manual for the Authenti-
cation Unit AU-102 and install the authentication
unit.
(12)
<When installing the Upgrade Kit UK-212 at the
same time>
Refer to the installation manual for the Upgrade
Kit UK-212 and install the upgrade kit.