E-2
(4) Remove the two seals from the control panel
right cover.
(5) Remove the two caps from the control panel left
cover.
(6) Remove the five screws and two tabs and
remove the control panel front cover.
Note:
Do not use too much force to remove the cover as
the harness is connected.
(7) Disconnect the connector from the board on the
control panel front cover.
(8) Connect the supplied harness to the local inter-
face board unit and route the harness inside the
edge cover.
Note:
• Insert the black connector into the local inter-
face board unit connector.
• Route the harnesses so that the cable tie is
located at the position shown in the illustration.
(9) Remove the USB cable from the main body.
(Two screws)
Note:
The two removed screws are used in later step.
Do not discard them.
Tab
Cable tie