E-4
<Installations to models 367/287/227>
(1) Turn OFF the power switch and unplug the
power cord from the power outlet.
(2) Connect the supplied harness to the local inter-
face board unit and route the harness inside the
edge cover.
Note:
• Insert the black connector into the local inter-
face board unit connector.
• Route the harness so that the cable tie is
located at the position shown in the illustration.
(3) Install the three supplied wire saddles to the local
interface board unit.
Note:
Install the wire saddles so that the lock faces out-
ward.
(4)
<When the optional Keypad KP-101 is mounted>
Remove the two screws and remove the cover
on the back side of the keypad. Disconnect the
connector and remove the keypad.
<When the optional Keypad KP-101 is not
mounted>
Remove the cover from the main body as shown
in the illustration. (Two screws)
(5) Open the front door of the main body.
Cable tie