Konica Minolta accuriopress c6085, Руководство по эксплуатации

Страница: 79 / 81

Automatic Inspection Operation Manual 9-2
9.1 If an Out-of-Range Image is Detected 9
9 Troubleshooting
9.1 If an Out-of-Range Image is Detected
Out-of-range image report status and remedy
When message "Out of range was detected." is displayed on the touch panel , check the out-of-range image
report.
No. Status Cause Remedy
1 A comment marked by a
red circle is displayed on
the out-of-range image
report, and also stains
are found on the actual
printouts. Out-of-range stains were
detected. Stains may be seen in the paper feed-
ing route. Perform maintenance for this
machine.
For details, refer to [Adjustments] or
[Machine Management] in the HTML
User's Guide.
2 A comment marked by a
red circle was displayed
on the out-of-range im-
age report, but no stains
are found on the actual
printouts. The inspection accuracy
level may be too high. Lower one of the following levels.
•
Inspection Level
• [Detection Level]
• [Paper Noise Removal Level]
The paper of the refer-
ence image and the ac-
tual printout is different. Load the paper that is used to create a
reference image.
Otherwise, load the paper you want to
actually use, and create a reference im-
age again.
The scanner unit of the
Intelligent Quality Opti-
mizer IQ-501
is dirty.
Clean the scanner unit.
For details, refer to [Machine Manage-
ment]
)
[Cleaning]
)
[Cleaning the In-
telligent Quality Optimizer IQ-501] in
the HTML User's Guide.
3 An error occurs in the
barcode inspection or
serial No. (0-9) inspec-
tion area. The original data is erro-
neous.
Or, the setting does not
match the specifications. Check the inspection data and decod-
ing results (CSV file in the report).
Also, check whether the barcode area
or serial No. (0-9) area is set based on
the specifications.
For details, refer to "7. Automatic In-
spection Area" in this manual.
4 A comment marked by a
pink circle is displayed
on the out-of-range im-
age report. A stain was detected on
the reference image, or
an out-of-range image
omission was detected. Perform maintenance for this machine,
and create a reference image again.
Otherwise, lower the [Inspection Level].
5 Message "Alignment er-
ror" is displayed on the
bookmark of the out-of-
range image report. The system failed in
alignment between the
reference image and the
inspection image. An alignment failure may occur on a
pale image or a simple image of ruled
lines only.
When this error recurs on a specific im-
age, set the entire target page to an ex-
cluding area in [Inspection Excluding
Area].
For details, refer to "7. Automatic In-
spection Area" in this manual.
A large stain is found on
an image. If any stain is found on the reference
image, create a reference image again.
If any stain is found on printouts, per-
form automatic inspection again after
carrying out maintenance of this ma-
chine.
The printed image is
completely different from
the reference image. Check whether the print job matches
the reference image. If no problems are
identified, create a reference image
again.