Kongskilde CM 305 F, Руководство оператора

Страница: 26 / 58

2. CONNECTION OR DISCONNECTION AND TEST DRIVING
PIGB 097A 05 CM 305F 0218
26
Fig. 2.10 Shortening procedure:
1) Separate the PTO shaft in two halves and mount these on PTO and PIC,
respectively, when these are at the same horizontal level. This corresponds with
the shortest possible length of the shaft on this machine and usually corresponds
with the working position when the machine rests on even ground.
2) Hold the ends of the shaft parallel side by side and mark the 30 mm (minimum) on
the tubes. See also fig. 2.10.
3) Shorten all 4 tubes equally.
4) Round off the ends of the profile tubes and remove burrs carefully with a file until
the tubes are smooth. It is important to deburr the inside of the outer tube and
the outside of the inner tube. Thereby the surface of the profile tubes is secured
against damage by sharp edges and impurities.
5) Clean the ends of the profile tubes of dirt and loose burrs.
WARNING: Lubricate the profile tubes carefully before reassembling. If the shaft
has insufficient lubrication it may lead to high frictional forces during
work which may cause the transmission to be overloaded.
When assembled the PTO shaft must be fastened to the PIC shaft.
Check that the PTO has sufficient overlapping in all positions by raising and lowering
the machine by means of the hydraulics.
SECURING AGAINST OVERLOAD
IMPORTANT: The tractor driver can secure the transmission against overload!
When using the machine, the following should be considered:
1) Always start the machine with the engine running at low speed. This especially
applies to tractors with electro-hydraulic connection of the PTO shaft.
Fig. 2.10