5
Tines:
Each tines must be assembled and then attached. Assembly is
straight forward simply look up the exploded view of the tine in
the "Spare Parts List." This contains all the information needed
to assemble the individual tines.
Once the tines are assembled, they must then be attached to the
toolbar. The position of the tines are described in guides canned
tine patterns.
A number of different tines patterns are available from Kongskilde, each of which
has been design for different soil conditions. Chose an appropriate pattern for the
conditions expected and then attach the tines where indicated by the pattern. The
actual attachment is shown in the picture in the upper right.
For the Res-Till the tines can be attached in a number of differen patterns.
These tine patterns show measurements from the center line (marked with an M)
of the cultivator frame to the center of each tine. Once the tine has been placed,
remember to tighten it.
Most tines can be assembled seperately and later attached to the frame. The VFM
tines is the exception (see next page).
The VTH Tine
An attached tine
Note:10cm or wider sweeps can not be placed on toolbar behind the
outer tandem wheels Sweep will interfere with tire. Use only 7 cm
goosefoots hare in these locations
A warning for those attaching tines