Installation
20220505H
105
transition speed is crossed (by more than 1 Knot higher or
lower speed).
•
Try the Dodge function and the U-turn.
•
If a Non-Follow Up lever (or handheld remote) is connected,
test the mode switching and verify Port and Stbd steering
commands of the lever.
•
Set waypoints into each navigator connected to the system,
and verify that the AP20 steers in NAV mode for each NAV
source.
•
If the boat is a sailboat use the WIND mode and try the AP20
at different settings of the apparent wind angle.
•
Provide the owner with user training.
Providing user training
The user should be instructed in the "basic" operational
functions, such as:
•
Turning the system on and off
•
Explain how to change modes (explain briefly what takes
place in the different modes).
•
Regaining manual control from any mode. Point out in what
modes the helm is engaged by the autopilot (bypass/clutch).
•
How to take command at an "inactive" station if applicable.
•
Lock mode and how to lock/unlock and how to shut the
system down from a locked control unit if applicable.
•
Show NFU and FU steering and explain the difference.
•
Review how to use a NFU controller if connected.
•
Course change by rotary knob and buttons.
•
Go through the user SETUP menu and show how to (and
why) change the settings.
•
Also include Nav. source, Pos. source and Compass sensor
selection if applicable.
•
Show the owner where the compass (or compasses) is
mounted and instruct him to keep magnetic items away.
•
Show where the Mains circuit breaker is.