Kongsberg HPR 400, Руководство по установке

Страница: 17 / 26

Installation Manual
13
130314 / F
Transceiver unit pin allocations
Introduction
The connectors on the rear of the HPR 400 Transceiver Unit
have the pin allocations as follows (as seen from outside,
looking at the rear of the unit).
Serial 1
The “Serial 1” socket is a 9-pin delta connector. It is located on
the rear panel of the HPR 400 Transceiver Unit, and is identified
with the label “SERIAL 1”.
It is used for communication with the computer. The inputs and
outputs are optically isolated.
The pins are allocated as follows:
1 422+ input
2 232 input
3 232 output
4 422- input
5 Ground
6 422- output
9 422+ output
Pins 7 and 8 are not used.
(CD1919)
1 5
6 9
Figure 2 9-pin Delta connector, seen from
the outside, looking at the rear of the unit
Serial 2
The “Serial 2” socket is a 9-pin delta connector. It is located on
the rear panel of the HPR 400 Transceiver Unit, and is identified
with the label “SERIAL 2”. It is only used for communication
with the HL 3880 TR tracking Hull Unit modules to control
transducer 1.
Not in use.
Serial 3
The “Serial 3” socket is a 9-pin delta connector. It is located on
the rear panel of the HPR 400 Transceiver Unit, and is identified
with the label “SERIAL 3”.
The Serial 3 line serves two purposes: