Kongsberg HPR 400, Руководство по установке

Страница: 11 / 26

Installation Manual
7
130314 / F
5 Position a rectangular threaded strip behind the captive
nuts, and screw the brass collar screws into the threaded
strip for two or three turns.
6 Position the assembled shelf/slide unit into the rack,
locating the lugs on the mounting brackets between the
captive nuts and the threaded strips.
7 Ensure the assembled shelf/slide unit is positioned
correctly, then tighten the collar screws.
Repeat this procedure for the remaining shelf/slide units.
Units and cables
1 Secure the electronic units to the appropriate shelves/rails
as required.
Note
You do not need to remove the circuit boards and modules from
the cabinet during the installation process. Keep the cabinet
door firmly shut. Ensure that the cabinet is not exposed to dust,
moisture, vibration or physical damage during the installation
process.
2 Install the electronic units into the rack.
3 Connect in the required cables and secure the cables to the
rack framework using suitable cable clamps. Ensure
enough slack is left to enable maintenance to be performed
on the units.
4 Mount the rear interconnection panel.
5 Mount the rack side panels (if not already mounted).
6 Referring to the applicable cabling and wiring
documentation and interconnection diagrams, connect in
the cables.
Warning Ensure all power supplies are switched off and
the fuses removed before attempting to connect
in the cables.
7 Once all the cables have been installed and the installation
has been checked, remove all “foreign” matter from the
cabinet and shut the door.
Caution Do not attempt to run the system before the checks
listed in the Test and Alignments section have been
completed.