Kongsberg ACS500, Инструкция по эксплуатации

Страница: 33 / 148

Getting started
2 Unlock the transducer cable by pulling the drum lock
G
slightly out.
3
Reel out the dunking transducer to the right depth, and lock the cable by pushing
the drum lock
G
back in.
4 Lift up the cover
D
to find the cable connection to the ACU.
5 Pull out the cable
E
and connect to the ACUs connector
B
.
Closing the cable drum
Note
Clean the unit, cable and transducer before storage.
Procedure
1 Roll up the cable
E
and place it inside the drum under the cover
D
.
2 Pull in the dunking transducer.
3 Clean the transducer and cable with freshwater.
4 Use the handle
F
to reel in the transducer cable.
5 Place the transducer in the basket.
6 Lock the transducer cable by pushing the drum lock
G
in.
7
Fold in the handle
F
.
8 Press the two bars
B
together and press the locking clip
C
into position.
Starting operation
Once you have powered up the complete ACS500 system, you are ready to start the
actual operation.
Topics
• Powering on the ACS500 on page 31
• Powering off the ACS500 on page 32
• Starting up the surface system on page 32
• Valve operation on page 33
Powering on the ACS500
Procedure
1
The SCU is powered up by inserting the battery and switching the stab connector on
the inside of the top end cap to on. Close the top end cap.
See Changing the battery on the Subsea Control Unit on page 80.
2 Power on the ACU by pressing the
Power
button
D
to the ON position.
The ACU takes about 1.5 minutes to start.
397128/C
31