Door Control Board: Board 1Ø4
®
for PM/SSC
Product Instruction
© 2000 KONE Inc.
61111-149
All rights reserved.
10
(R3) 2000-08-31
TIP: If doors do not operate smoothly,
particularly on slower moving doors, it
may help to remove jumper J3. This
eliminates dynamic braking, and
allows a smoother transition between
speeds.
A604-SI6 (2/97)
ADJUST DOOR SPEEDS
1.
Disconnect and tag-out power.
2.
Remove door operator cover and close doors.
3.
Set switches and potentiometer in following
positions.
●
All speed control potentiometers - fully
counter-clockwise.
●
C.C.L. potentiometer - Fully clockwise.
●
TEST-RUN switch - TEST position.
●
O-OFF-C switch - OFF (center)
position.
●
Two position jumper J4 - just to right,
and slightly above, R01 relay.
(Standard position if one pair of wires
is present at TB3. High Performance if
two pairs of wires are present at TB3.)
4.
Apply power. Toggle O-OFF-C switch to “O”
position. LED6 next to “PL” potentiometer
illuminates, indicating doors are in PL zone.
5.
Turn “PL” potentiometer clockwise until doors
begin to open. When “PL” microswitch drops,
LED next to “PL” potentiometer goes out, and
LED next to “OF” potentiometer illuminates.
6.
Turn “OF” potentiometer clockwise, just enough
to move doors through “OF” speed zone. When
“OSDL” microswitch drops, LED next to “OF”
potentiometer goes out, and LED next to “OS”
potentiometer illuminates.
7.
Turn “OS” potentiometer, just enough to move
door through “OS” speed zone. When “OL” cam
activates “OL” microswitch, LED next to “OS”
potentiometer goes out. Doors should be fully
open.
8.
Toggle O-OFF-C switch to C position. LED next
to “CF” potentiometer comes on.
9.
Turn “CF” potentiometer clockwise until doors
begin to move. When “CSDL” microswitch is
dropped by its cam, LED next to “CF”
potentiometer goes out and LED next to “CS”
potentiometer illuminates.
10. Turn “CS” potentiometer clockwise until “CL”
microswitch is actuated by its CAM. LED next to
“CS” potentiometer goes out. Doors should open
and close at slow speed.
➤
If doors do not fully open or close within
20 to 30 seconds, internal timer
removes motor power and LED 7 is lit.
➤
If board senses over 5 amps, power
shuts down and LED 7 is lit.
11. Using speed zone potentiometer and CAM
settings, adjust door speeds for desired
performance. Green LED’s indicate which speed
control potentiometer is controlling door speed.
➤
Increase door speed — turn
potentiometer clockwise
➤
Decrease door speed — turn
potentiometer counterclockwise
Do not set potentiometer P8. It is
factory-set and sealed.
A604-020 (4/97)
