Komatsu PC210-8, Руководство по ремонту

Страница: 410 / 1200

UEN00228-04 30 Testing and adjusting
36
PC210, 230, 240-8
Measuring and adjusting oil
pressure in pump LS control
circuit 1
a
Measuring and adjusting tools for oil pressure
in pump LS control circuit
k
Stop the machine on a level ground and
lower the work equipment to the ground.
Then, release the residual pressure from
the hydraulic circuit. For details, see
“Releasing residual pressure from hydrau-
lic circuit”.
Measuring
a
Before measuring the oil pressure in the PC
control circuit, check that the oil pressure in the
work equipment, swing, and travel circuits and
the basic pressure of the control circuit are nor-
mal.
a
Measure the oil pressure in the pump LS con-
trol circuit under the following condition.
q
Hydraulic oil temperature: Within operating
range
1. Measuring LS valve output pressure (servo
piston inlet pressure)
a
Measure the LS valve output pressure
(servo piston inlet pressure) and pump
discharge pressure simultaneously and
compare them.
1) Open the side cover of the pump room
and remove oil pressure pickup plugs (1),
(2), (3), and (4).
q
(1): Front pump discharge pressure
pickup plug
q
(2): Rear pump discharge pressure
pickup plug
q
(3): Front LS valve output pressure
pickup plug
q
(4): Rear LS valve output pressure
pickup plug
2) Install nipples M3 and nipples [1] of
hydraulic tester M1 and connect them to
oil pressure gauges [2].
a
Connect the measuring part of plug
(3) by using joint (790-301-1271) and
elbow (790-301-1530) of hydraulic
tester
M1 and nipple [1] so that it will
not interfere with the drain piping.
a
Use the oil pressure gauges of 58.8
MPa {600 kg/cm
2 }.
Symbol Part No. Part name
M
1
799-101-5002 Hydraulic tester
790-261-1204 Digital hydraulic tester
2 799-401-2701 Differential pressure gauge
3
799-101-5220 Nipple (10 × 1.25 mm)
07002-11023 O-ring
PC210/230-8
1
2
Warning:Test points reversed
on PC210/230-8 pump
3
4
PC240-8
PC210/230-8
M3
M3
M3
1