Komatsu PC200-8M0, Руководство по ремонту

Страница: 463 / 1254

SEN06128-00
PC200, 200LC, 220, 220LC-8M0 30-102
43
102 Testing and adjusting, Part 2
Special functions of machine monitor
a
The cut-out cylinder is not automatically reset
even after returning to the operator mode.
Accordingly, be sure to perform the resetting
operation after the Cylinder Cut-out operation
is finished.
5. Holding displayed data
Each time [F4] is pressed during the Cylinder
Cut-out operation, the displayed data is newly
held (c) (the real-time data is kept displayed on
the left side).
While the data is held, if [F4] is pressed, the
data holding function is reset.
a
The holding function is available for a cyl-
inder, regardless of whether it is cut out or
not.
[Reference]
q If a normally operating cylinder is dis-
abled, the following phenomena occur.
1) The engine speed lowers.
2) The value (quantity) of final injection com-
mand increases.
q If the engine is running near the full speed,
however, the engine speed may not lower
for the reason of engine control.
q In this case, lower the engine speed by
using the fuel control dial and judge by
increase of the injection rate command.
Adjustment (Pump Absorption Torque (F))
The machine monitor allows for adjustment of vari-
ous items related to the machine with the machine
monitor.
The sub menu of Pump Absorption Torque (F) is
used to finely adjust the absorption torque of the
front hydraulic pump.
1. Selecting the menu
Select “Adjustment” on the “Service Menu”
screen.
2. Selecting sub menu
After the “Adjustment” screen is displayed,
select “Pump Absorption Torque (F)” using the
function switches or numeral input switches.
a
Select this sub menu as in the case of
selecting a menu on the “Service Menu”
screen.