Komatsu HD465-8, Руководство по эксплуатации и техническому обслуживанию

Страница: 196 / 420

6) Fill the fuel tank with fuel through the fuel filler port (F).
7) Move the switch (9) for the fuel feed pump to ON posi-
tion, and bleed air from the fuel circuit.
After the fuel feed pump stops automatically and the
lamp (10) goes out, move the fuel feed pump switch
(9) to ON position again.
Check again that the lamp (10) has gone out.
6.
Close the cover (2) of fuel prefilter and tighten the wing
bolts (1).
METHOD FOR CHECKING OIL LEVEL IN STEERING AND HOIST OIL TANK,
ADDING OIL
k k
WARNING
• Immediately after the engine is stopped, its parts and oil are still very hot and may cause burn in-
jury.
Wait for the temperature to go down, and then start the work.
• When removing the oil filler cap, the oil may spurt out. Turn it slowly to release the internal pres-
sure, then remove it carefully.
1.
Check the oil level with the sight gauge (G).
If the oil is seen from the sight gauge (G), the oil level is
correct.
2.
If the oil is not seen from the sight gauge (G), add the oil
through the oil filler port (F).
METHOD FOR CHECKING OIL LEVEL IN BRAKE SUB TANK, ADDING OIL
k k
WARNING
• Immediately after the engine is stopped, its parts and oil are still very hot and may cause burn in-
jury.
Wait for the temperature to go down, and then start the work.
• When removing the oil filler cap, the oil may spurt out. Turn it slowly to release the internal pres-
sure, then remove it carefully.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-144