Komatsu Galeo HD325-6, Руководство по эксплуатации и техническому обслуживанию

Страница: 300 / 317

.
ATTACHMENTS, OPTIONS
HANDLING AUTO-GREASING SYSTEM
PRECAUTIONS WHEN HANDLING AUTO-GREASING SYSTEM
Basically, the power source input to the lubrication controller should be DC24V, but use a maximum limit of 30V.
The grease nipple installed to the service port used for initial charging of the divider valve has a ball check
structure, so it may leak if dirt gets stuck in it.
Check it from time to time, and replace the grease nipple immediately if any grease is leaking.
When carrying out initial operation or when the grease tank is empty, air may get into the piston portion of the
pump. If the pressure does not rise within the specified time when running the pump, and an error is displayed
for the controller, bleed the air.
If the divider valve or grease piping are removed when replacing the attachment on the machine, handle carefully
to prevent any damage. When storing or installing again, be extremely careful to prevent the entry of air, and
particularly dirt. If there is any air in the system, bleed the air immediately.
TROUBLESHOOTING
If any problem occurs in the greasing system, the error codes will flash alternately to display the type of problem.
Error code Item Cause Remedy
E
→
a Defective
pressurizing of
pump Air in main piping
Air inside pump
Grease tank is empty
Grease leaking from main
piping
Run pump as necessary and release
grease from end of piping to bleed air
Release grease from air bleed in pump
to bleed air
Add grease
Check,tighten connections of main piping
(including hoses)
E
→
b Abnormality in
release of
pressure Abnormality in
pressure-releasing
structure built into pump
Abnormality in
pressure-detection
equipment built into pump Disassemble pressure-releasing portion
carefully, then check and clean
Check limit switch at pressure-detection
portion
E
→
c Abnormality in
pressure
detection Abnormality in
pressure-releasing
structure built into pump
Abnormality in
pressure-detection
equipment built into pump Check limit switch
Check limit switch at pressure- detection
portion
E
→
0 Empty tank Greasing frequency limit
has been reached
Grease added during
frequency count Add grease
Confirm that 0 flashes three times on
7-segment LED by pressing reset button
on controller for more than 5 seconds.
6 - 37