Kolver 033001, Руководство оператора

Страница: 39 / 89

Vers. 111422 39
Example
The running torque window was
incorrect: it extended past the
seating point.
The severity of the problem was
reduced by using the average
running torque value.
Note : if the running torque value is higher than the desired clamping torque value, you will
also need to superimpose a prevailing torque phase to the running torque phase, to enable
the screwdriver to finish the running torque phase at a higher torque value than the
TARGET Torque , as the running torque value is not added to the target torque until the end
of the running torque window.
Final test with running torque compensation
After fine-tuning the running torque detection.
Perform another batch of tests and analysis to verify the desired result.
Example
Target torque: 2.22 Nm
Running torque mode:
Average - Compensate
Window: 270° – 4000°
Example
The running torque value is greater than
the clamping torque target
This requires the prevailing torque phase
during the running torque phase