Kollmorgen MMC Smart Drive Series, Руководство по оборудованию

Страница: 130 / 386

128 Kollmorgen - June 2014
MMC Smart Drive Hardware Manual
-
460V 3 PHASE MMC SMART DRIVE NEXTGEN
Table 6-4: Pin Description for Feedback Connector (F1)
F1 Feedback Signals
Signal Type Signal Name Notes Pin
Incremental Encoder
Inputs
A1, A1/, B1, B1/, I1, I1/
Differential A quad B encoder
signals.
12, 13, 14, 15, 6, 7
Sinewave Encoder In-
puts
Sin, Sin/, Cos, Cos/ Sinewave Encoder signals 12, 13, 14, 15
Sinewave Encoder
Data Channel In/Out
RS-485 Data +, RS-485
Data -, RS-485 Clock+,
RS-485 Clock- RS-485 signals for connecting
the Sinewave Encoder Data
Channel to the drive
6, 7, 2, 3
SFD Communication
Channel
Com+, Com-
SFD communication signals.
An SFD can be connected to F1
or F2, not both
6, 7
Resolver Inputs Sin+, Sin-, Cos+, Cos-
Resolver stator feedback sig-
nals
12, 13, 14, 15
Resolver Outputs , Carrier-
Resolver rotor excitation sig-
nals.
6, 7
Temperature Input Temperature
Thermostat (normally- closed)
or Thermistor (Phillips KTY84-
130 PTC or equivalent recom-
mended) input for detecting
over temperature conditions
within the motor. These inputs
are shared with F2.
8, 9
+5V Encoder Power
Outputs
+5V Source
Reg5VDC for powering
the attached encoder (350ma
max).
10
+5V Encoder Power
Sense Lines +5V Sense+, +5V
Sense-
These signals should be tied to
the +5V power and ground lines
at the encoder.
4, 5
Signal and Power
Common
Common
Return path for feedback sig-
nals and +5V power output
11
PROVIDING 8VDC ENCODER POWER
Some Encoders, specifically the Stegmann Hiperface, require 8VDC power to operate. 8VDC Power
can be provided on pins 10 and 11 by connecting the +5V Sense Lines (pins 4 & 5) together.