Koldwave AIRMASTER 3AK, Руководство по установке и эксплуатации

Страница: 7 / 20

7
KOLDWAVE 3AK (AIRMASTER)
CONDENSATE REMOVAL
The Koldwave Airmaster incorporates a 5.0 gallon
capacity, polyethylene, condensate drain tank, located
in the lower front section of the unit. A high water level
cut-out switch, installed on the bulkhead behind the
compressor as shown in the photo, is used to stop the
entire unit’s operation automatically when the tank is
full of water. An adjustment screw is provided to set the
desired water tank level when the unit cuts out. Turn
screw clockwise to lower water level and thus
decrease the tank’s weight for emptying. To prevent
spillage when carrying filled tank, a cap is chained to
the tank top.
CAUTION: Turn unit off before emptying tank when
tank light is illuminated.
There are three methods in which to remove
condensate water from unit:
1. With condensate tank and water level detection
system, which comes standard on unit. See
detailed drawing and discussion below.
2. With optional condensate pump kit shown on page
16.
3. By gravity draining out bottom of unit. This is
accomplished by connecting a hose to bottom of
evaporator drain pan and routing through a 3/4"
hole in base pan located just to the left of the
condensate tank tray. A snap-in plug has to be
removed from hole to permit this.
WATER DETECTION SYSTEM
An adjusting screw sets the desired water level in the
tank anywhere from 1 gallon minimum to 4 gallon
maximum. Once the desired water level in the tank has
been reached the unit will shut down and not restart
until the condensate tank is emptied and replaced.
To reduce water level in tank from factory setting, turn
adjusting screw clockwise…
2-1/2 Turns = 3.5 gallons
4-3/4 Turns = 2.5 gallons
6-3/4 Turns = 1.5 gallons
1. Condensate Tank
2. Water Level Detection Control
2
1