Koldwave AIRMASTER 3AK, Руководство по установке и эксплуатации

Страница: 16 / 20

16
KOLDWAVE 3AK (AIRMASTER)
CONDENSATE PUMP KIT
SA 057-D-0048
(OPTIONAL)
A condensate pump, capable of pumping against an
11 foot head, can be installed for positive removal of
evaporator condensate. This kit is a convenience for
those who do not wish to empty the five gallon
condensate tank periodically, especially for units with
permanent installation. At the condensate pump, a
check valve is inserted in the hose and secured by two
plastic clamps. Installation of the pump kit into the unit
can be accomplished by the simple steps below.
PROCEDURE TO INSTALL
CONDENSATE PUMP KIT
ASSEMBLY
1. Disconnect unit power source.
2. Open front lower hinged door.
3. Pull out plastic drain hose form
inside of tank and remove tank
from hinged tray. (Do not drain
hose from evaporator drain
pan).
4. Mount pump kit assembly in
hinged tray using the two holes
provided in left side of tray. Use
the two machine screw and hex
nuts to secure the pump kit.
5. Route clear plastic hose from
pump through a hole in the
base pan. Hole is plugged by a
knockout button which should
be removed.
6. Route pump wire leads through
bulkhead wall (through Heyco
star-shaped bushing).
7. Route pump wire leads through
plastic bushing in electrical box
and connect to terminal strip
positions 2 and 6.
8. Insert plastic drain hose from
evaporator pan into the drain
tube clamp provided on the
pump kit assembly.