qb701 User
’s
Manual
17
Press
- to toggle data input
–
LD
transducer’s data /
MD
–
manual data
Press
- to toggle angle input
–
IA
use inclinometer /
MA
manual angle. Manual angle
input used for vertical machines, when electronic inclinometer cannot be used.
Press
- to toggle displayed precision
–
2 or 3 digit.
Press
then
- to toggle measurement
mode:
Turn 3
- clock mode
9-12-
3 o’clock
–
readings
to be taken at three predefined shaft positions
–
9
o’clock, then 12 o’clock, then 3 o’clock
. After that,
device will proceed to the result screen.
Turn 4
points
–
readings to be taken at four
predefined shaft positions separated by 90°
or 45°
(3hr / 1:30hr). After that the device
will proceed to the result screen.
Multipoint
mode
–
measurements may be taken at any of minimum 3 up to 36 positions.
After taking enough readings one should press
to proceed to the result screen.
TOLERANCE SETUP
Press
to enter tolerance setup menu.
Press
to use predefined RPM/tolerance table
Press
to enter user defined tolerance values
Press
to save changes,
to discard changes.
9
3
12
S
M
