1.6
loosen the Grubscrew with the .5 mm hexagon Key (supplied) and remove
the Backplate from the thermostatic mixer.
1.7
Secure the Backplate to the wall using the Securing Screws (supplied).
1.8
Fit the concealing Plates.
note!
Apply silicone sealant to the back face of the flange.
Caution!
It is essential at this point that the supply pipework is thoroughly
flushed through before connection to the Thermostatic Mixer. Failure to do so
may result in product malfunction.
1.9
Fit the compression Nuts and olives onto the pipework.
1.10
Align the Thermostatic Mixer with the pipework and fit onto the Backplate.
1.11
tighten the compression Nuts onto the thermostatic mixer with a suitable
Spanner.
Caution!
take care not to damage the chrome surfaces.
1.12
tighten the Grubscrew with a .5 mm hexagon Key (supplied) to secure the
thermostatic mixer to the Backplate.
1.13
Fit the Shower Fittings, refer to your Fittings Installation and user Guide for
instructions.
note!
For high pressure systems, a 12 litre/minute flow regulator (supplied) can
be fitted under the hose washer.
1.14
turn on the hot and cold water supplies and check for leaks.
1.15
the maximum temperature of the thermostatic mixer is factory set to approximately
43°c. If adjustment is required, refer to section:
‘Commissioning’
.
Flow regulator
(for high pressure
systems)
Grubscrew