Kohler Mira Zest, Руководство пользователя

Страница: 20 / 29

19
Malfunction Cause Remedy
No hot water from
shower, with the
knobs in any
position. Other water outlets are
being used during
showering, causing the
water pressure to drop
below the minimum
required.
Temperature cycles
between hot and
cold. The temperature is set too
high. This is causing the
thermal switch to turn off
the heating element to
reduce the water
temperature.
The power is off at the
double pole switch. Switch on the power at the
double pole switch.
Renew the fuse or reset the
MCB/RCD. If the fault persists,
contact the shower installer.
Make sure the other water
outlets, such as the washing
machine or dishwasher, are not
in use during showering.
Make sure that the incoming
water supply stop and the
isolating valve are completely
open. If the fault persists,
contact the shower installer.
Contact installer to replace
faulty parts.
Failure of pressure switch,
micro switch or thermal
switch.
Turn the temperature knob
anticlockwise to reduce the
water temperature.
The water pressure is
b e l o w t h e m i n i m u m
required.
ALL OF THE FOLLOWING REMEDIES MUST ONLY BE
PERFORMED BY A COMPETENT TRADESPERSON!
No hot water from
shower, with the
knobs in any
position. Insufficient water supply
pressure.
Failure of the pressure
switch, microswitch or
thermal switch. Contact the local water
authority.
Check the continuity of the
switches, using a suitable
continuity measuring device.
Replace the switches as
necessary.
Check the integrity of the
internal wiring.
An internal wiring
connection has failed.
One of the heater tank
elements has failed.
Replace the heater tank.
Switch assembly
diaphragm fault, water
dripping from the unit. Replace switch assembly.
The fuse is blown or the
MCB/RCD has been
tripped, indicating a
possible electrical fault.