ÍÍÍ
ÍÍÍ
ÍÍÍ
ÍÍÍ
Tank Lid
Threaded Rod
1/16"
Actuator Rod
Fig. #15
SERVICING THE TANK TO BOWL
ASSEMBLY
1. Shut off water supply to toilet. Flush toilet.
2. Remove tank lid from tank by unscrewing the plunger/
actuator assembly. Remove brass nut and washer be
low the tank, then pull out rubber washers, brass wash
ers, and brass screws from inside the tank.
Remove
tank from base.
ÉÉÉÉÉÉ
ÉÉÉÉÉÉ
ÉÉÉ
ÉÉÉ
ÇÇ
ÇÇ
ÇÇÇÇÇÇ
ÇÇÇÇÇÇ
ÇÇÇÇÇÇ
ÇÇÇÇÇÇ
ÇÇÇÇÇÇ
ÇÇÇÇÇÇ
ÇÇÇÇÇÇ
ÇÇÇÇÇÇ
Bottom
of Tank
Bowl
Rubber
Washer
Metal
Washers
Fig. #16
Tank Gasket
Brass
Washer
Nut
3. Remove gasket between tank and bowl.
4. Place the new gasket around the nut.
5. Carefully check alignment of the holes on tank and
base. Insert new rubber washers, brass washers, and
brass screws inside the tank. Make sure the tank
screws extend through the holes in the toilet base. As
semble brass washers and nuts to screws underneath
tank.
CAUTION: DO NOT OVERTIGHTEN OR
BREAKAGE AND CHIPPING MAY OCCUR
.
6. Reassemble tank lid to tank. Screw push button into
place.
7. Turn water supply to toilet on. Flush toilet for proper op
eration. Check for leaks.
SERVICING THE THREADED ROD
1. Shut off water supply to toilet.
2. Remove tank lid by unscrewing the push button (use
the palm of your hand.
Refer to Fig. #11.
Next, re
move tank from bowl: remove brass nut and washer
below the tank, then pull out rubber washers, brass
washers, and brass screws from inside the tank. Set
aside.
ÉÉÉÉÉ
ÉÉÉ
ÇÇ
ÇÇÇÇÇ
ÇÇÇÇÇ
ÇÇÇÇÇ
ÇÇÇÇÇ
ÇÇÇÇÇ
ÇÇÇÇÇ
ÇÇÇÇÇ
ÇÇÇÇÇ
Fig. #17
Bottom
of Tank
Bowl
Rubber
Washer
Metal
Washers
Tank Gasket
Brass
Washer
Nut
3.
Refer to Fig. #18.
Remove old threaded rod by push
ing it through the flush valve and out the bottom . From
underneath the tank, insert new threaded rod through
the flush valve.
Make sure the two engagement pins
are clipped in the slots of the valve.
ÍÍ
ÍÍ
ÍÍ
ÍÍ
ÍÍ
ÍÍ
ÍÍ
ÍÍ
ÍÍ
ÍÍ
Threaded Rod
Valve
Body
Engagement
Pin
Fig. #18
4.
Refer to Fig. #19.
Insert actuator rod into threaded
rod.
