Kohler K-2593-VBW-0, Руководство по установке

Страница: 15 / 68

10. Install the User Interface
IMPORTANT! Do not allow the cable routed through the wall hole to fall into the wall.
Push a thin nail into the groove in the back side of the user interface to separate the interface from
the mounting plate.
Position the mounting plate over the cable and against the finished wall so the hooks are to the left.
Level the mounting plate and mark the screw hole locations on the wall.
Remove the mounting plate and drill 1/4
″
holes at the marked locations.
Insert the provided wall anchors into the holes.
Apply a bead of 100% silicone sealant to the two grooves on the back of the mounting plate.
Position the mounting plate over the cable with the hooks to the left, and secure to the wall using
the two screws provided.
Check for level. If needed, loosen the screws and adjust the mounting plate.
Connect the cable to the user interface.
Engage the edge of the user interface with the two mounting plate hooks, then firmly swing the
user interface against the mounting plate until they snap together.
Refer to the User Guide included with the user interface to set up, program, and verify proper
function of the product.
Anchors
Horizontal and
Vertical
Adjustment
Hooks
Screws
Pencil
100% Silicone
Sealant
Front View Back View
Mounting
Plate
User
Interface
Kohler Co. 15 1237790-2-D