Kohler K-10673, Руководство по обслуживанию

Страница: 14 / 76

Clean/Replace the Diaphragm
NOTICE: Ensure that the wires do not get caught between the cap
and the valve body.
Close the control stop valve.
NOTE: If the unit has not flushed since the stop valve was closed,
the inlet arm may still be pressurized. Use manual flush button to
release pressure.
Using a 3/32
″
hex wrench, remove the setscrew from the cap.
Remove the cap from the valve body.
Pull the connectors apart to disconnect the DC sensor connector
from the solenoid connector.
Temporarily store the cap and DC sensor assembly in a safe
place.
Using an adjustable wrench, remove the solenoid.
Remove the diaphragm.
NOTE: Take care not to lose any small parts contained within the
solenoid assembly.
Rinse any debris from the diaphragm.
If replacing, insert a new diaphragm in the valve.
Insert the diaphragm with the plastic side facing out from the
valve.
Valve Body
Diaphragm
Cap
Setscrew
O-Ring
Piston
Retaining Nut
Pin
Spring
DC Sensor
Connector
Solenoid
Connector
Solenoid
Assembly
Piston
Cover
1108709-5-C 14 Kohler Co.