EFI SYSTEM
40
19 690 01 Rev. --
KohlerEngines.com
Diagnostic Fault Code Summary
Fault Code
Connection or Failure Description
0031
Oxygen Sensor Heater Circuit Low Voltage
0032
Oxygen Sensor Heater Circuit High Voltage
0107
Manifold Absolute Pressure (TMAP) Circuit Low Voltage or Open
0108
Manifold Absolute Pressure (TMAP) Circuit High Voltage
0112
Intake Air Temperature (TMAP) Circuit Low Voltage
0113
Intake Air Temperature (TMAP) Circuit High Voltage or Open
0117
Coolant/Oil Temperature Sensor Circuit Low Voltage
0118
Coolant/Oil Temperature Sensor Circuit High Voltage or Open
0122
Throttle Position Sensor Circuit Low Voltage or Open
0123
Throttle Position Sensor Circuit High Voltage
0131
Oxygen Sensor 1 Circuit Low Voltage, or Open
0132
Oxygen Sensor 1 Circuit High Voltage
0171
Maximum Adaptation Limit Exceeded
0172
Minimum Adaptation Limit Exceeded
0174
Lean Fuel Condition at High Load (Open Loop)
0201
Injector 1 Circuit Malfunction
0202
Injector 2 Circuit Malfunction
Function Test
WARNING
High Pressure Fluids can puncture skin and
cause severe injury or death.
Do not work on fuel system without proper
training or safety equipment.
Fluid puncture injuries are highly toxic and hazardous.
If an injury occurs, seek immediate medical attention.
Function of fuel system is to provide suf
fi
cient delivery
of fuel at system operating pressure of 39 psi ± 3. If an
engine starts hard, or turns over but will not start, it may
indicate a problem with EFI fuel system. A quick test will
verify if system is operating.
1. Disconnect and ground spark plug leads.
2. Complete all safety interlock requirements and crank
engine for approximately 3 seconds.
3. Remove spark plugs and check for fuel at tips.
a. If there is fuel at tips of spark plugs fuel pump and
injectors are operating.
b. If there is no fuel at tips of spark plugs, check
following:
1. Make sure fuel tank contains clean, fresh,
proper fuel.
2. Make sure that vent in fuel tank is open.
3. Make sure fuel tank valve (if equipped) is fully
opened.
4. Make sure battery is supplying proper voltage.
5. Check that fuses are good, and that no
electrical or fuel line connections are damaged
or broken.
6. Test fuel pump module operation as described
earlier under Fuel Pump Module (FPM).
Fault Codes
Example of Diagnostic Display
One second pause
One second pause
One second pause
One second pause
Three second pause
(0)
(0)
(7)
(6)
(1)
(1)
End Code 61
Fault
Code
0107