Kohler Command PRO CH270, Руководство по обслуживанию

Страница: 120 / 126

11.22
Section 11
Reassembly
Oil Sentry Oil Sentry TM TM
Module Module
Wire Wire
Connections Connections
Figure 11-81. Installing Fuel Tank.
2. Install two hex fl ange nuts on the fuel tank studs.
See Figure 11-82.
Hex Screw Hex Screw
Figure 11-82. Installing Fuel Tank Hardware.
3. Torque the side strap screw to 10 N·m (89 in. lb.) .
See Figure 11-83.
Hex Nuts Hex Nuts
Figure 11-83. Torque Side Strap Screw.
4. Torque the remaining screw and nuts to 24 N·m
(212 in. lb.) .
5. Position the fuel line in the clip on the bo tt om
of the tank. Connect the fuel line to the shut-
o
ff valve on the carburetor and secure with the
clamp. See Figure 11-84.
Figure 11-80. Reconnect Electrical Leads.
2. Connect the electrical leads for the Oil Sentry™
module. See Figure 11-80.
Install Fuel Tank
1. Position the fuel tank on the mounting brackets.
Secure with hex screws on the inner mounting
bracket and on the PTO side strap. See Figure
11-81.
Install Oil Sentry
™
Module
NOTE: If the Oil Sentry™ module is mounted inside
the control panel, skip this step.
1. Install the Oil Sentry™ module and secure with
one hex screw. See Figure 11-80. Torque the screw
to
3.5 N·m (31 in. lb.) .