Kohler COMMAND CV11, Руководство по обслуживанию

Страница: 133 / 148

11.11
Section 11
Reassembly
11
Figure 11-32. Torquing Flywheel Fastener (Electric
Start Models).
5. Install the grass screen onto the fan assembly
(electric start models). See Figure 11-33. If the
engine originally had extra retainers on three of
the snap knobs, you were instructed to mark
those knobs during the disassembly procedure.
Install new retainers (Part No. 24 018 03-S) on
the opposite three knobs from where the original
retainers were located.
Figure 11-33. Installing Grass Screen (Electric Start
Models).
Install Hydraulic Lifters
Adjustable Valve Lash Configuration Only
1. Bleed the hydraulic lifters of internal oil so the
plunger in the lifter can be depressed by hand. Use
an old cutoff push rod mounted in a drill press,
arbor press, or vice, and slowly apply pressure two
or three times to bleed the lifters. See Figure
11-34. If a vice is used in bleeding the lifters, be
sure to install protective coverings over the jaws to
avoid damage to the base of the lifter(s).
Figure 11-34. Push Rod Tool.
NOTE: Another tool for bleeding may be made
from an old tappet and ball bearing
welded together. See Figure 11-35.
Figure 11-35. Tappet and Ball Bearing Welded
Together.
All Head Configurations
1. Lightly lubricate the bottoms of the lifters with oil
and install into their respective bores. See Figure
11-36. Do not prime the lifters.
NOTE: Hydraulic lifters should always be
installed in the same position as before
disassembly.
Grass
Screen
Fan
Exhaust
Valve Lifter
Intake
Valve Lifter
Figure 11-36. Installing Hydraulic Lifters (Camshaft
Removed to Show Lifter Positions).