Koden MDC-2900, Руководство по эксплуатации

Страница: 98 / 191

MDC-2900 Series Chapter 3 Primary operations (Menu)
0093129012-06 3-39
ACTIVE / SLEEP
[ACTIVE/SLEEP] status of target can be switched by using a trackball, dragging a cursor to the desired
target and then pressing [ENT] key.
FILTER [Sleep targets only]
When there are many AIS targets, the screen may become unclear. In that case, by setting filters, it is
possible to hide unnecessary sleeping targets or to display the necessary targets only, and then the
clear view of the target can be acquired.
* The filter is absolutely used to limit display. When input is to be limited, [INPUT RNG] shall be
operated.
Refer to “
INPUT RNG: Input range
” (page3-21)
Only target within specified [CPA/TCPA] is displayed.
FILTER
1
Use a trackball and drag a cursor to [FILTER CPA/TCPA] at the upper right part of the screen.
Press [ENT] key to get ON.
Refer to “
CPA/TCPA
” (page3-16) to setup [CPA/TCPA].
The set items to be changed on the screen are [Range] and [Class].
RNG: It displays targets only within specified range.
*Pay attention that the objective target may not be displayed if the setup value is too small.
CLASS: It displays targets only in setup class.
In addition, [MOORED], [AT ANCHOR], [SPD], [GZ] and [ECHO ALARM] are settable on the menu.
Refer to “
AIS FILTER
” (page4-18) to setup [CPA/TCPA].
AIS AUTO ACQ
This function automatically changes sleep target to the larger activated target (hazardous target).
It is essentially the same function as [AUTO ACQ AREA].
Even if an active target enters, no response occurs.
Refer to “
AUTO ACQ AREA: Automatic acquisition area
” (page3-22)
for [AUTO ACQ AREA].
When the sleep targets within specified CPA/TCPA value are changed to active targets:
1
Use a trackball and drag a cursor to [AUTO ACQ CPA/TCPA] on the upper right part of the screen.
Press [ENT] key to get ON
Refer to “
CPA/TCPA
” (page3-16) to setup [CPA/TCPA].
In addition, [RNG] is used to activate the targets within designated range.