Koden MDC-2900, Руководство по эксплуатации

Страница: 48 / 191

MDC-2900 Series Chapter 2 Basic operation (Panel)
0093129012-06 2-17
Measure distance/bearing (PI: Parallel index line)
This function is used to display a parallel straight line from the reference point.
Refer to “
Setup own ship profile
” (page1-5) to set up reference point.
Display location (distance, bearing) of each line can be changed independently. The length of LINE can
be also designated.
Refer to “
Bearing mode set up
” (page3-12) to set up the bearing mode.
[Bearing mode] can be changed directly in the lower left of the screen, with trackball and [ENT] key,
without using menu function.
All lines displayed can be simultaneously changed. When lines of fixed length are required to be used,
please change the mode to “PI MODE”.
Refer to “
PI MODE
” (page4-22).
1
Push [VRM] knob, and PI is displayed.
When pressing [VRM] knob again, line number will be changed and will be turned off after the last
number of line.
1/4
1/4
3/4
3/4
5/4
5/4
6/4
6/4
OFF
Line number / The total number of display
2
While activated, the bearing and range are shown at the lower left and lower right of the center of
the display, respectively.
The lamp color of PI located at the lower left of [VRM] knob changes.
Push
VRM knob
PI 1/4
000.0°
3.000NM
PI RE L 1/4
3
The range of selected line can be changed by turning [VRM] knob.
* Turning [VRM] knob (while pressing it) changes the range quickly.
Increase of
range
Decrease of
range
VRM knob
PI 1/4
000.0°
3.000NM
PI RE L 1/4