Volume
(0~127): Sets the operator’s volume.
Feedback Source
(1~6)
[OP1 only]:
Selects which operator output will be fed back into
OP1.
Feedback Level
(0~127)
[OP1 only]
: Sets the level of the feedback loop.
Fixed
: Toggles between Fixed or Multiplicative operator frequency mode. In
Multiplicative mode, it follows MIDI note frequencies with multiplier applied to it, while
in Fixed mode, it stays always the same.
Multiplier
(0~40)
[only in Multiplicative mode]
: Sets the operator frequency multiplier.
Original frequency depends on incoming MIDI note pitch.
Quartertones
(0~24)
[only in Multiplicative mode]
: This parameter allows you to set the
operator frequency by quarter-tone steps.
Fine
(-100~+100)
[only in Multiplicative mode]
: This parameter allows you to fine tune
the operator’s frequency.
Freq. Multiplier
[only in Fixed mode]
: Sets the base multiplier for the fixed frequency.
Available values are 0.1, 1, 10 and 100
Freq. Fine (0 ~ 255)
[only in Fixed mode]:
Sets the operator frequency according to the
multiplier above.
Frequency indicator
[only in Fixed mode]
: This number shows you the operator actual
frequency in Hertz. It’s useful to accurate the two previous parameters.
VOL EG TAB:
This envelope allows you to control the operator’s
volume during time. See Envelope Edit section to
know more about envelope manipulation.
If the selected operator is a carrier, you should end its
envelope with a value of zero, otherwise the voice
will never stop playing. Simply press the panic button
if a note is stuck.
Tip:
to quickly get the same envelope on different operators simply focus the envelope,
press Copy, select another operator then press Paste.
A whole operator can also be copied if you press Copy when the operator is focused.
18
Содержание EssenceFM
Страница 1: ...English Other languages and PDFs available at kodamo org...
Страница 2: ......
Страница 40: ...Memo 39...
Страница 41: ......