Replacing Projection
lamp and Cleaning
Projection lens
Projection
Lamp: Loosen the lamphouse
cover screw and lift off the lamphouse
cover. (See Figures lland12.)
WARNING:
Projection
lamps get
very hot in use. Make sure the
lamp is cool before you handle it.
Cooling can be accelerated
by
running the projector without film
(with the lamp off).
To remove the LAMP,grasp it just in front
of the LAMPSOCKET
and pull upward to
release the lower rim from the two
retaining
hooks at the front; lower the
lamp from the RETAINING
SPRING,but do
not unhook the spring. Then pull the
socket from the back of the lamp.
To insert the new lamp, reverse the
procedure given above. Be certain that
the socket is pushed completely
onto
the connecting
pins at the back of the
lamp and that the rim of the lamp is fully
seated on both of the retaining
hooks on
the mounting
plate. Avoid touching
the
small bulb inside the lamp reflector.
If it is touched accidentally,
clean it
with alcohol and a clean cloth.
It is recommended
that a SPARE
PROJECTION
LAMPbe carried in the
projector
lamphouse at all times.
Cleaning Lens: The projection
lens
should be cleaned with care. Remove
the projection
lens by drawing it out of
the lens holder. With a soft, lintless
cloth or KODAKLens Cleaning Paper,
carefully wipe the front and rear lens
surfaces. Do not use a wet cloth; if
moisture is required, breathe on the
lens or use a drop of KODAKLens
Cleaner.
WARNING:
The use of treated
papers or cloths can harm the
LUMENIZEDsurface of the lens.
LAMPHOUSE
COVER
SCREW
SPARE
LAMP
FIGURE 11
SPARE LAMP HOLDER
LAMP CONTROL
15
FIGURE 12
LAMP
