7
Commands and effects
Function
Code
*Setting dissolve times
(Soft Slide Change in single projection)
801 - 899
*Random Access
0-160
Fade (MASTER)
770
Fade (SLAVE)
707
Alternate (Crossfading without slide
change)
777
*Freeze
789
Independant Projector Control Mode
980
Parallel Projection Mode
Activate Focus for SLAVE°
970
666°
Reactivating of the dissolve mode
990
*Remote Security Mode
989
*Reset
999
*Auto-Timer
600 - 660
Important
The dissolve time you have input is re-
tained until you overwrite it with a new
time (via the IR remote control). After a
reset (switching off and back on again)
the time you have input with the IR
remote control is deleted (see basic
set
ting).
F
SELECTING SLIDES
As in the case of individual projection,
you can transport backwards and for-
wards at will, or select slides directly
(random access). The slide sequence is
always retained and the projector which
is currently dark is automatically car-
ried to the next slide in your presentation.
Tip
√
The last code input via the numerical
keypad of the IR remote control remains stored.
If the command has to be reinput, it is only
necessary to press the <*> key.
√
If you input an incorrect figure on the
numerical keypad of the IR remote control,
press clear <C> before reinputting your figure.
o
Function is inactivated for models 7010 and
9010!
english
Overview
The following table gives and overview
of all commands and effects. All com-
mands with * can also be used for projec-
tion with a single EKTAPRO 7010, 7020,
9010 or 9020 Projector!
F
DISSOLVE
Basic setting
After switching on you can immediately
begin a dissolve presentation. Dissolving
takes place with a default time of 0.5 sec-
onds.
As soon as you press the transport for-
wards button of the remote control both
slide trays go to position 1 and the MAS-
TER projector fades the no. 1 slide up at the
specified time. If you push the button again
the first dissolve happens: slide no. 1 is
faded down in the specified time and at the
same time slide 2 is automatically faded up.
Then the slide tray of the MASTER projec-
tor is automatically transported one posi-
tion further and the projector is ready for
the next dissolve. The dissolve process
also functions in the same way when you
push the transport backwards button.
Notes:
You can interrupt a presentation if the
dissolve time is greater than one second.
If a dissolve has already started, it can be
interrupted by pressing the forward but-
ton again at lest 1 sec into the dissolve.
The presentation will move on to the next
slide. Continuously pressing the forward
button will interrupt each dissolve after
one second and move on to the next.
Dissolve times with IR remote control
You can input dissolve times of
0
seconds
(so-called hard cut) up to a long dissolve
of
9.9 seconds
in increments of
a tenth of a second. The numer-
ical combinations of
800 ...899
on your remote control are
reserved for this. Please
ensure that you press the
ENTER button <*> after
inputting the relevant combination. Only
then is the command received by the pro-
jector and the time stored. As soon as you
press the transport button on your remote
control, the first dissolve takes place.
Examples:
If you want a dissolve time of
1 s
:
è
Input <810> and confirm with <*>.
5.5 s
:
è
Input <855> and confirm with <*>.
0 s (Hard Cut)
:
è
Input <800> and confirm
with <*>.
