Calibration Utility for MACINTOSH
2–36
September 1997 Part No. 1H9659
Running a Densitometer Calibration
If you have a densitometer, you can run the Densitometer calibration
instead of the Visual Gray Balance and Visual Linearity calibrations.
1. Set up your densitometer.
2. Pull down the Calibration menu and select
Densitometer.
3. Pull down the Calibration menu and select
Setup Densitometer....
The Calibration Setup – Densitometer dialog box appears.
4. Select a densitometer status in the
Densitometer box.
5. Pull down the
Number of Squares menu in the Test Print box and
select the number of squares in your test print.
6. Click on the
OK button.
