E N G L I S H
Thank you for choosing the CLASSICTONE-SE from KOCH. You now own a "state-of-the-art" all-tube
Single Ended full Class-A guitar amplifier of the highest quality. The CLASSICTONE-SE has been
designed and built by people who - from their own experience as musicians - take guitar sound and
quality very seriously. That is why this product was designed and built with the utmost care in order to
meet all professional standards. Our goal was not only to design an amp which sounds fantastic and is
easy to operate, but also to build it in such a way that it will serve you loyally for many years to come.
Please take your time to read this manual carefully before you switch on the CLASSICTONE-SE and
also please fill in the warranty card and mail it. Thanks and lots of success with your new
CLASSICTONE-SE !
CAUTION:
* BEFORE PUTTING INTO OPERATION READ THESE OPERATING INSTRUCTIONS
CAREFULLY.
* NO USER SERVICEABLE PARTS INSIDE.
* REFER SERVICING TO QUALIFIED SERVICE PERSONNEL ONLY.
WARNING:
* TO REDUCE THE RISKS OF ELECTRICAL SHOCK, DO NOT REMOVE THE
COVER.
* TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD, DO NOT EXPOSE
AMPLIFIER TO RAIN OR MOISTURE.
* THIS APPARATUS MUST BE EARTHED.
* TUBES ARE HOT. DO NOT TOUCH DURING OPERATION.
FRONT PANEL FUNCTIONS
[1] INSTRUMENT
- Input for all types of instruments,
e.g. guitars with single-coil, humbucker or active
pickups.
[2] EXTERNAL PREAMP
- Input for the Koch
Pedaltone or any other preamp.
[3] VOLUME:
A Clean sound is achieved at lower
settings (1 to 3), at higher settings (3 to 10) overdrive
occurs which will produce more sustain and real
power amp distortion.
[4] GAIN BOOST:
Increases the gain for adding extra
overdrive and distortion.
[5] TONE:
Classic passive tone control for adding or
cutting the high frequencies
[6 & 7] VOICING SWITCHES
MID SHIFT: Shifts the operating frequency of the
TONE control from the standard frequency of 2 KHz
down to 500Hz (“boost”), thus creating a very natural
and musically sounding boost in the middle
frequencies.
BASS CUT: With this switch a filter can be activated
that cuts the low frequencies so low notes don’t get
muddy at high GAIN settings
[8] MASTER:
Controls the overall volume level.
[9] RECORDING/PA
This jack is an unbalanced mono output suitable for
recording or PA. Its signal is derived from the speaker
output. This signal is shaped by a special filter that
simulates the typical recording characteristic of a
microphone placed in front of a guitar speaker.
The output signal is at line level (-10 dBV).
[10] STANDBY SWITCH:
Allows the
CLASSICTONE-SE to be placed in Standby, Low
Power or Full Power mode.
In Standby mode the tubes remain hot, but the
amplifier is not operational.
In Low Power mode the power amp delivers only 1/3
of the indicated power (2 or 4 Watt).
In Full Power mode the power amp delivers the
indicated power (6 or 12 Watt)
[11] POWER SWITCH:
Turns AC power On (red LED
on) and Off (red LED off). When the switch is Off the
amplifier is completely shut down.
NOTE: When switching the amplifier On, leave the
Standby switch [10] in the “Standby” position for 5-10
seconds thus allowing the tubes to heat up before
switching to Low or Full Power mode.
Содержание CLASSICTONE-SE
Страница 9: ......