Kobold NGR, Руководство по эксплуатации

Страница: 34 / 59

6 Menu overview
34
Parameter Description
EXPRT See Chapter 5.1 "Expert mode"
TrsHld This value describes a factor which determines how strong an echo has to be
in order to be recognized by the device. The value range lies between 20% and
500%. The default is 100% in this case. Only shown if password entered.
●
20% = high sensitivity
●
100% = standard
●
500% = low sensitivity
Offset See Chapter “5.10 Setting the offset”
MaxCol See Chapter “5.2 Filtering measured values”
MeasMd Measuring mode
●
HiSpd: max. length = 2,005 mm, response time < 400 ms
●
HiAcc: max. length = 6,005 mm, response time < 2,800 ms
(more stable measured values, recommended for liquids with low DK values
and where the TrsHld is < 70)
●
mode-1: not supported, deactivates current AutCal/foam calibration
Length See Chapter 2.3 "Foam commissioning (with factory settings)"
CalRng Calibration area/Calibration length (calibration range)
●
Value range: 95 to 6,005 mm
●
Factory setting: 500 mm
Range starting from the process connection in which static interference signals
(coupling sections, welds, spray balls, etc.) are hidden during the AutCal process.
During the AutCal process, there must not be any medium in the defined area of
+200 mm.
CblLen See Chapter “5.7 Changing the coaxial cable length”
Lock See Chapter “5.8 Activating the display lock”
Unit See Chapter “5.9 Selecting the display unit (millimeter/inch)”
Foam See Chapter 2.3 "Foam commissioning (with factory settings)"
CalEmp See Chapter 2.3 "Foam commissioning (with factory settings)"
CalMed See Chapter 2.3 "Foam commissioning (with factory settings)"
FomSta Status of the foam calibration, read-only access
●
inactv: CalEmp and/or CalMed not successful or not performed.
Foam treatment inactive.
●
active: Foam treatment active
Limit Limit between foam and fluid
●
Range: 20 to 100%
●
Factory setting: 90%
●
Medium surface: 90%
●
Foam surface: < 90%
When measuring the foam surface, it may be necessary to reduce the limit. If the
sensor displays a limit value that is too low, it is necessary to reduce the limit.