Kobold NGR, Руководство по эксплуатации

Страница: 27 / 59

5 Advanced functions
27
5.7 Changing the coaxial cable length
(in preparation)
■
Valid for versions with remote amplifier.
■
This setting makes it possible to configure the coaxial cable length between the sensor head and
process connection.
Configuration
■
Predefined coaxial cable length (1,000 mm, 2,000 mm, or 3,300 mm)
■
Log into expert mode (see Chapter “5.1 Expert mode”)
■
Configure the coaxial cable length in the EXPRT-Config-CblLen menu (1,000 to 3,300 mm)
Note:
Only the following configurations are permitted:
Max. probe length [mm]
Coaxial cable length [mm] Foam mode inactive Foam mode active
1,000 4,000 2,000
2,000 3,000 1,500
3,300 1,000 500
5.8 Activating the display lock
■
To prevent the sensor from being tampered with, password protection can be activated for the
display.
■
When the protection is active, the expert password (000537) must be entered before the menu
can be accessed.
■
The menu is only unlocked once the correct password is entered.
Configuration
■
Log into expert mode (see Chapter “5.1 Expert mode”)
■
The protection can be (de)activated via the EXPRT-Config-Lock menu.
Note:
■
The user is logged out again after 5 minutes of inactivity.
■
When the display is locked, only the configured measured value display (DspVal) can be seen
5.9 Selecting the display unit (millimeter/inch)
■
This setting makes it possible to display and configure all length measurements in either millime -
ters or inches.
Configuration
■
Log into expert mode (see Chapter “5.1 Expert mode”)
■
Set the unit in the EXPRT-Config-Unit menu (mm/inch)