HND-F215
HND-F215 K07/0522
page 15
Data Logger:
As soon as key "Store" (key 6) is pressed and .
Func = Stor
. is chosen, a data set
will be stored. The data stored can either be observed on the display (prt. "How to
Display Individual Values" below), or be read into a PC via the interface.
When .
CYCL
. is set and the logger has been started using key "Store" (press for
2 seconds), data sets will be stored till the recording is either stopped or the
logger memory is full. (not available with HND-FF… and "AVG Hold") The logger
cycle time can be set. Use the interface to input the data stored into a PC.
If the logger contains already data, the connected kind of sensor
(HND-FF31, HND-FF33, HND-FF32) must not be changed. In such
case the instrument would display "Sens Erro". Functions like the
read out of logger data or clear the memory are still accessible.
Storing of Individual Values: "Func Stor"
Data set that can be stored: 99
One data set consists of: measuring value channel 1 - 6 and time + date
Press "Store"-key to store current values. .St.XX. will be displayed for a short
time, XX representing the number of the data set 1..99.
If the logger memory is full a warning will appear on the display:
(warning triangle permanently shown, cyclic display of "LoGG FuLL"
and the current measuring value)
Upon pressing the "Store"-key (key 6) for 2 seconds the selection for deleting the
logger memory will be displayed assumed that there are any logger data.
delete all data sets
delete data set recorded last
do not delete (= cancel
procedure)
Use the keys "
" (key 2) or "
" (key 5) to make a selection. Use key "Quit"
(key 6) to acknowledge selection.
How to display Individual Values:
Individual values can also be displayed without interface which is not possible
with the cyclic logger function.
If there are data sets in the logger memory, the additional main menu .rEAd
LoGG. will be offered upon call-up of the menu (press key "Set" (key 4) for 2 sec).
When the "
"-key (key 3) is pressed the last data set will be displayed. Use "
"-
key (key 3) to change over between the values of one data set (channel 1 - 6,
date/time).
To change over from one data set to another use the keys "
" (key 2) or "
"
(key 5).
