Kobalt 1447232, Руководство пользователя

Страница: 14 / 56

14
OPERATING INSTRUCTIONS
5. Before Using the Chainsaw:
a. Remove the battery pack.
b. Make sure that the chain is properly mounted and correctly tensioned.
c. Lift the tip of the guide bar (I) up to check for any sagging in the saw chain (J)s. The saw
chain is correctly tensioned when there is no sag on the underside of the guide bar and
the saw chain is snug, but it can be turned by hand without binding. If the tension requires
adjustment, refer to the section: “ Replacing the Bar and Chain ” in the Maintenance
section of this manual for adjustment instructions.
d. Check the tension of the side-cover knob (F) before use. If it is loose, securely tighten the
side-cover knob by turning it clockwise.
e. Check the oil level and fill the tank as needed.
f. Check the cutting teeth sharpness of the saw chain.
g. Make sure the saw chain is well lubricated.
h. Make sure the chain kickback brake handle moves easily to the brake position, then pull
the saw chain kickback brake handle back towards the front handle to the operating
position.
i. Stand upright and hold the chainsaw in a relaxed position.
j. Make sure the saw chain is not touching the ground or any other objects.
k. Hold the chainsaw with both hands: with the right hand on the rear handle and the left
hand on the front handle.
l. Make sure that you have a secure and balanced footing. Watch out for obstacles such as
tree stumps, roots and ditches, which could cause you to trip or stumble.
6. Preparation for Cutting
Refer to “ safety information ” earlier in this manual for appropriate safety equipment.
Work Area Precautions
• Cut only wood or materials made from wood; do not cut sheet metal, plastics, masonry, or
non-wood building materials.
• Never allow children to operate the chainsaw.
• Allow no person to use this chainsaw who has not read this Operator’s Manual or received
adequate instructions for the safe and proper use of this chainsaw.
• When felling a tree, keep everyone - helpers, bystanders, children, and animals - a safe
distance from the cutting area. During felling operations, the safe distance should be a
least twice the height of the largest trees in the felling area. During bucking operations,
keep a minimum distance of 15 feet (4.5 m) between workers. Trees should not be felled
in a manner that would endanger any person, strike any utility line or cause any property
damage. If a tree does make contact with any utility line, stay clear of the tree and the line
and notify the utility company immediately.
• Always cut with both feet on solid ground to prevent being pulled off balance.
• Do not cut above chest height, as a saw held higher is difficult to control against kickback
forces.
• Do not fell trees near electrical wires or buildings.
• Cut only when visibility and light are adequate for you to see clearly.
Proper Grip On Handles
• Wear non-slip gloves for maximum grip and protection. With the saw on a firm, flat surface, hold
the saw firmly with both hands.
• Always grasp the front handle (D) with the left hand and the rear handle (B) with the right
hand.