3.3.2 INDIVIDUAL ADDRESS ASSIGNMENT
To download the desired Individual Address or an ETS setting the Programming Mode must be activated.
Successive pressing the Programming Button will turn on and off the Programming Mode. LED 7 lighting
in red colour indicates Programming Mode is active. When Programming Mode is activated, the ETS is
able to download the Individual Address.
A blinking red Programming LED indicates the Ethernet cable is not properly connected or no IP
network connection is available.
Also when Boot Mode is active, successive pressing the Programming Button will turn on and off
Programming Mode and Programming LED.
To configure the device an interface connection (IP, USB) to the KNX bus system is required. The device is
supplied with the Individual Address 15.15.0. The KNX product database entry (available for ETS4 and
higher) can be downloaded from the website and from the KNX Online Catalog.
The Individual Address can be assigned to the device by setting the desired address in the properties
window of the ETS. A er starting the ETS download and then pressing the Programming Button the
device restarts itself.
3.3 PROGRAMMING
3.3.1 PROGRAMMING BUTTON
Figure 1.
ETS properties window
page 9
module-electronic.ru
