5 WEB FRONT-END
The web front-end can be used to read out
IC-IP-S.1.0
´s actual device parameters (HTTP port, IP address,
MAC address, …), to update its firmware and to adjust the (additional) tunneling addresses. To identify a
particular
IC-IP-S.1.0
of a KNX network the Programming LED/Programming Mode can be remotely
switched on and off without pressing the on-device Programming Button.
To switch back from Boot Mode to normal operation in is necessary to run the firmware update
procedure and then abort, or wait for the 10 min timeout.
5.1 ACCESSING THE IC-IP-S.1.0 WEB FRONT-END
There are three ways to access the
IC-IP-S.1.0
. It can be accessed like a Microso Windows UPnP network
device (Windows7 or later) and by a web browser. For access by a web browser either the IP address or
the MAC address, together with the HTTP port, have to be known. How to use IP address and MAC address
with the browser´s URL bar is described in the following.
For access via web browser the HTTP port that is set by ETS (or the factory default parameter value)
has to be used.
IC-IP-S.1.0 is able to use both official HTTP system port (80 and 8080).
Factory default HTTP port is 8080.
page 14
module-electronic.ru
