5.4 FIRMWARE UPDATE / BOOT MODE
Under the Update tab the
IC-IP-S.1.0
firmware can be updated via IP i.e. the Ethernet network like
described in following steps. During the remote update process
IC-IP-S.1.0
enters Boot Mode. Then LEDs
1, 2, 3, and 7 light as described in Table
2
.
If Boot Mode is already active only the web front-end instructions from step 3 to step 5 must be
followed (refresh, request update).
Boot Mode is still active a er device reset and a er factory reset.
To exit Boot Mode it is necessary to enter the Update tab of the web front-end. Then either the firmware
update has to be completed (if a new firmware is available) or the firmware update process has to be
stopped by a click on the
«
Abort
»
button. A er that
IC-IP-S.1.0
restarts and continues with normal
operation.
Step 1:
Open the update tab of the web front-end.
Figure 10.
Update tab
Step 2:
Activate programming mode (KNX tab or programming button).
Figure 11.
Update tab and activated programming button
page 19
module-electronic.ru
