KNX GIRA 5110 00, Руководство пользователя

Страница: 12 / 42

Commissioning
RF/TP media coupler/repeater | Order no. 5110 00 | 51103300 Page 12 of 42
￭ Press programming button again and hold about 2 seconds until status LED
lights up yellow.
The device is in "Repeater prog. mode".
￭ Release the programming button.
￭ Commission the device with a physical address x.y.z (z≠0).
￭ Load the Physical Address to the device via the TP side (if the device is con-
nected to the TP line of the associated media coupler) or the RF side. The
ETS also automatically loads the domain address of the RF line into the
device.
The status LED goes out.
After the physical address has been successfully programmed, the device can
no longer be reached with the ETS via the TP side, because the device's TP
transponder is switched off! This feature is necessary because from a topolo-
gical standpoint, a repeater (without media coupler function) is exclusively as-
signed to the RF line, and no longer to a TP line. Consequently, afterwards the
application program can only be programmed separately via the RF side. To
do so, either a programming connection via the media coupler of the RF do-
main can be used (TP -> RF) or alternatively, a KNX RF USB data interface.
Where necessary, the TP line of the media coupler can be used for voltage supply to
the repeater (see chapter "Mounting and electrical connection"
}
Page 8).
When programming the repeater via RF: For the programming of the physical
address and the domain address to be carried out and completed correctly,
the domain address of the RF line must match the domain address of the RF
communication interface (e.g. KNX USB RF data interface)! Otherwise, com-
munication errors can be expected. The domain address of the KNX RF USB
data interface used is configured in the general connection settings of the
ETS. In an ETS project, the domain address of an RF line or a repeater is con-
figured in the line properties (separate for each RF line).
￭ Load the application program into the device using the ETS.
In pure repeater operation, the filter table has no function.
Commissioning a device with a marking up to "I01"
￭ Press the programming button.
The status LED lights up red. Programming mode is activated.
￭ Load the Physical Address to the device via the TP side (if the device is con-
nected to the TP line of the associated media coupler) or the RF side. The
ETS also automatically loads the domain address of the RF line into the
device.
The red status LED goes out.