4
INSTALLATION
• Fit the pins on the frame into the slots of the saw table
bracket.
• Assemble the flat washer and table lock handle. Tighten
the saw table to the saw frame by turning the table lock
lever clockwise.
Table lock
handle
Angle
adjustment
knob
5. Fix the band saw
to a workbench by
using four thread
forming screws
(not provide).
Place the fence
Miter gauge onto
the table.
Fence
Miter
gauge
Thread
forming
screw
ADJUSTING
WARNING
Always be sure that the tool is switched
off and unplugged before any adjustments.
1. Tilting table
• Loosen the table lock handle slightly.
• Turn the angle adjustment knob, tilting the saw table
until it reaches the desired angle.
• Using the scale indicator, check angle markings.
• Retighten the table lock knob to hold saw table securely
in place.
Angle
adjustment
knob
Table
locking
handle
2. Aligning the saw blade
If the saw blade does not run in the center of the rubber
tyre, the tracking needs to be corrected by adjusting
the tilt of the upper band saw wheel.
Open the upper and lower cover. Manually rotate
the upper wheel, taking care no to touch the blade.
Turn tracking set knob clockwise or anticlockwise until
the saw blade tracks centered on the rubber tyre.
After adjusting, retighten the tracking lock knob
and close the cover.
Upper
cover
Tracking
set knob
Lower
cover
