KNOVA KN M-2509RC, Руководство пользователя

Страница: 10 / 64

4
3
2
1
Fig. C
2
9
ASSEMBLY
WARNING
WARNING
To avoid injury, do not connect this miter
saw to the power source until it is completely
assembled and adjusted and you have read and un-
derstood this instruction Manual.
To avoid injury and damage to the saw,
transport and store the miter saw with the cutting
head locked in the down position. Never use the
stop latch to hold the cutting head in a down
position for cutting operations .
INSTALLING THE MITER HANDLE (FIG. C)
1. Insert the miter handle (1) into the hole in front of the miter
saw and align the hole (2) on the miter handle (1) with the
hole (3) in the front of the table.
2. Thread the screw (4) through the hole (3) in the table into
the hole (2) on the miter handle (1).
3. Tighten the screw (4) with a screwdriver.
RELEASING CUTTING HEAD (FIG. A)
Raising
1. Push down slightly on the trigger switch handle (1).
2. Pull out the hold-down latch (2).
3. Raise the cutting head to the uppermost position.
NOTE : This cutting head is spring loaded.
SAW BLADE WRENCH STORAGE (FIG. D)
For convenient storage and prevention
of loss, there is a slot in the side
of the trigger switch handle (1)
for storing the blade wrench (2)
when not in use.
Locking
When transporting or storing the miter saw, the cutting head
should always be locked in the down position.
1. Push the cutting head down.
2. Press the hold-down latch (2) in to lock.
IMPORTANT : To avoid damage, never carry the miter saw by
the trigger switch handle or the cutting arm.
INSTALLING THE DUST BAG (FIG. B)
1. Install the dust bag assembly (1) onto the exhaust port (2)
on the miter saw. Fit the connecting tube of dust bag
assembly and the exhaust port together.
NOTE :
• The dust bag assembly should be angled toward
the right side of the saw for best results. This will also
avoid any interference during the saw operation.
• To empty the dust bag, pull out the dust bag
assembly from exhaust port. Open zipper on underside
of bag and empty into waste container.
IMPORTANT : Check frequently and empty bag before
it gets full.
WARNING
Do not use this saw to cut and/or sand
metals. The hot chips or sparks may ignite sawdust
from the bag material.
Fig. A
1
1
2
Fig. B
Fig. D
2
1