KNOVA KN 9832-G, Руководство пользователя

Страница: 9 / 33

8
OPERATION
PRE-OPERATION CHECK LIST
• Read and understand this operator manual in its entirety
before operating pressure washer.
• Check oil level and add oil to the proper level if low.
• Check fuel level and add fuel if needed.
• Check connections of handle and all hoses to make sure they
are secure.
• Check all hoses for kinks and damage.
• Check flow of water supply and make sure it is adequate.
Do not operate or start engine in a confined space preventing
dangerous carbon monoxide gas from dissipating.
• Carbon monoxide gas is a poisonous, odorless gas that can
cause fainting, sickness, seizures, or death.
• Keep exhaust from this unit from entering a confined area
through windows, doors, vents, or other openings.
• When working in areas where vapors could be inhaled, use a
respirator mask according to all of its instructions.
Do not run pressure washer with a damaged hose. Do not run
pressure washer without first connecting and turning on water
supply or damage to the pressure washer could result. Failure to
follow these instructions will void product waranty.
STARTING PRESSURE WASHER (SEE FIG 8 & 9)
• Place pressure washer on a level surface.
• Turn on water.
• Purge the system’s pump of air by releasing the safety and
squeezing the trigger of the spray gun.
• Attach wand/lance to spray gun.
• Turn fuel valve to the ON position.
• Slide the choke lever to the “Choke” position.
• Turn the engine OFF/ON switch to the “ON” position.
• Pull the recoil handle (starter cord) slowly until resistance is
felt, then pull rapidly.
• Let engine run for several seconds and then gradually slide the
choke lever to the RUN position as the engine warms up until
the choke is fully slid to the RUN position.
Starter cord recoils rapidly pulling arm towards engine faster
than you can let go which could result in injury.
• Always relieve pressure from spray gun before pulling starter
cord, including every failed attempt to start engine.
• To avoid recoil, pull starter cord slowly until resistance is felt,
then pull rapidly.
Fig. 9
Recoil Starter
STOPPING PRESSURE WASHER
• Turn the on/stop switch to the OFF position.
• Turn the fuel valve to the OFF position.
• Turn off water and squeeze the trigger handle to release water
pressure.
USING THE SPRAY GUN (SEE FIG 10 & 11)
• Flip the lock tab behind the trigger up or down until it clicks
to apply or remove the safety. Pull back on the trigger to begin
operating pressure washer.
• To stop water flow, release trigger.
Fig. 10 Fig. 11
Lock out
Slot
WARNING
WARNING
WARNING
Engine Switch
Choke
Fig. 8
CHOKE RUN
ON
OFF
CAUTION
Trigger